Filter
Top Products
Hardware Installation
Page 31
Connecting the Power Cord
The type of AC power cord supplied with the library depends upon the configuration ordered, and the
country of destination.
To connect the power cord:
1. Make sure that the power switch on the back of the library is off (the 0 is pressed).
Figure 17. Power Cord Connection
2. Connect the female end of the power cord to the power connector on the back of the library.
3. Plug the male end of the power cord into the power source.
NOTE
The library has autoranging voltage selection, so you do not need to
change the voltage setting.
Power
switch
Power
connector