Filter
Top Products
Library Operation
Page 67
The following diagram shows the element index assignments for the library.
Figure 25. V15 Element Indexes
Element Addresses
Your application software may use element addresses to identify elements in the library. The difference
between an element index and an element address is that an index is a fixed number set in the library’s
firmware, whereas an address can be changed by your application software (using the SCSI command,
MODE SELECT).
The library’s default element addresses correspond to the element indexes.
Using the Demo Menu
The Demo option causes the robot to randomly move cartridges from slot to slot, including the fixed
cartridge slots.
To run the demo option:
1. If necessary, disable security.
2. Change the robot mode to LCD.
3. Make sure there is at least one cartridge present and one empty slot before you begin the
test.
4. From the operator panel keypad, press [MENU] to display the menus. Press the down arrow
key until “Demo Menu” displays, as shown below.
D e m o
M e n u
83
7 6 5 4 3 2 1
86
Fixed Cartridge
Slots
Magazine
Tape Drive
Robot
13 14 15
8910
1211 82