Filter
Top Products
Configuration
Page 43
Setting the Clean Cycles Left Option
The Clean Cycles Left option is a counter that tracks the number of times a cleaning cartridge has been
used. When you install a new cleaning cartridge, you must use this option to set the number of cleaning
cycles that remain. After completing a cleaning cycle, the library automatically decreases the Clean Cycles
Left counter by one.
NOTE
Refer to the information provided with your cleaning cartridge to
determine how many cleaning cycles it contains.
To set the Clean Cycles Left option:
1. If the security option is enabled, disable it.
2. Display the Config Menu. If necessary, press [MENU] to display the menus. Press the down
arrow key until “Config Menu” displays, then press [ENTER].
3. Press the down arrow key to display “Cleaning Tape Cycles Left.”
NOTE
To set the Cleaning Cycles Left option, the clean slot must contain a
cleaning cartridge, and the Clean Slot option must be enabled.
4. Press [ENTER]. The following screen displays.
5. Use the arrow keys to set the number of cleaning cycles that remain on the installed
cartridge, then press [ENTER].
C l e a n i n g T a p e
C y c l e s L e f t : 1
C l e a n i n g C y c l e s
L e f t ? 1
↑