Filter
Top Products
Configuration
Page 47
2. Press [ENTER]. An informational message displays, then the following screen appears.
3. Use the left and right arrow keys to move across the columns. Use the up and down arrow
keys to select a number. When you have selected a password, press [ENTER]. A prompt
similar to the one below appears.
4. Press [ENTER] to accept the new password. The Security Screen then displays “LCD
Password.” (Security remains in effect across resets.)
NOTE
You must use the same password to turn security off.
Disabling Security from the LCD
1. Display the Security screen. If necessary, press [MENU] to display the menus (or return to the
top of the menu selections). Press the down arrow key until “Security” is displayed on the
screen, as shown below. If security is enabled, “LCD Password” displays on this screen.
NOTE
Security may have been enabled by your application using a SCSI
command (the LCD will display “SCSI”). If this is the case, security
must be disabled by your application. Refer to your software
documentation or to the Plasmon V15 SCSI Reference.
2. Press [ENTER]. The following screen appears.
3. Use the left and right arrow keys to move across the columns. Use the up and down arrow
keys to select a number. Press [ENTER]. Security is then disabled.
P a s s w o r d ? 0 0 0
← b →
P a s s w o r d : 0 0 0
A c c e p t ?
S e c u r i t y
L C D P a s s w o r d
P a s s w o r d ? 0 0 0
←
b
→