Filter
Top Products
Plasmon
V
15 AIT Tape Library User Manual
Page 54
To connect the Ethernet cable:
1. Insert one end of the cable into the Ethernet port until you hear it snap into place.
2. Connect the other end of the cable to the server where you plan to install the Library Monitor
software.
Monitoring the Ethernet LEDs
The Ethernet light-emitting diodes (LEDs) indicate the operating status of the Ethernet connection. The two
LEDs are located above the Ethernet port, as shown below.
Figure 21. Ethernet LEDs
The Link LED turns on when a link to the network has been established. The Activity LED blinks when data
transmission or reception is taking place.
Link LED
Activity LED