Filter
Top Products
Configuration
Page 37
Operator Keys
Use the operator keys to perform the following actions:
Table 3. Operator Keys
Error Codes
If a hardware error occurs, an error code appears on the Status Screen, one frame at a time. Refer to
Appendix C for help in diagnosing and correcting errors. You must correct the error before operation can
continue.
Configuring the Library
This section describes how to set the library’s configuration options. Refer to the table below for an
explanation of each configuration item and determine which ones you need to set. Then follow the
appropriate steps in this section to set those options.
NOTE
Ethernet configuration, control modes and sequential mode
configuration are described later in this manual.
Key Description
(Arrow keys)
Moves up, down, left, or right through the menus and
screens, depending on which directional arrow you press.
[ESCAPE] Returns to the previous menu or screen, or cancels an
operation without saving changes.
[ENTER] Selects the item next to the screen arrow or accepts a
change.
[STATUS] Displays the Status Screen, which shows library status,
tape drive status, and operator messages.
[MENU] Displays a menu of options for configuring the library, view-
ing information screens, and issuing commands to the
library.
[UNLOCK DOOR]
Stops robot operations and releases the door’s interlock
mechanism. The door can then be opened manually.
[RESET] Displays the Reset screen, which allows you to reset the
library.