Filter
Top Products
Cisco SN 5428 Storage Router
Zone Configuration
P
AGE 86 QLOGIC SWITCH INTEROPERABILITY GUIDE
VERSION 1.0, MARCH 2003
Zone Configuration
This section discusses configuring active Zone Set names and Zone types.
Active Zone Set Names
The Zone and Zone Set names on each switch must be unique. If not, change one of the duplicate
names. All Zone Set and Zone names must conform to the Fibre Channel (FC) Standards for Zone
Naming (ANSI T11/00-427v3):
1. Must be 1–64 characters in length.
2. All characters are ASCII.
3. First character is [a–z] or [A–Z].
4. All other characters must be [a–z], [A–Z], [0–9], or the _ character. Other characters ($-^) may
not be supported by all vendors and should be avoided.
NOTE: Zone and Zone Set names cannot be set using the Cisco SN 5428 Management Interface
nor the Cisco CLI. Use the QLogic SANbox Manager GUI or QLogic CLI.
Cisco SN 5428 Management Interface
Not applicable.
Cisco CLI
Not applicable.