Filter
Top Products
INSTALLATION
ULTRAMATRIX E-SERIES MANUAL
11
Switch Installation – Single Unit
The basic installation of a single UltraMatrix switch is an easy and
straightforward procedure. Perform the below steps for all computers
that will be connected. It is recommended that all computers be
powered off. When a computer is connected and then booted, the
UltraMatrix will automatically determine the keyboard and mouse types
used for that computer and no pre-configuration is needed.
Figure 3. Single Unit configuration
The Unit in Figure 3 can be any UltraMatrix 2xE or 4xE model
If removing power from a computer is not practical, pre-configure the
UltraMatrix to define that CPU port’s keyboard and mouse types. This
procedure should only be done if the CPUs keyboard and mouse can
be disconnected and re-connected without affecting the interface.
The default keyboard type is PC mode 2, and the default mouse type is
PS/2. If the computer being connected, with power applied, uses a
PC2 keyboard and PS/2 mouse, no pre-configuration is needed. If not,
pre-configure the keyboard and mouse types for that CPU port before
connecting the computer (steps 4a-4f).
Please refer to the safety section before installation
KVM Station
(1 of 4)
CPU
Cable
KVM
Cable
PC’s
(1 of 16)