Filter
Top Products
ULTRAMATRIX E-SERIES MANUAL
13
8. When all computers are connected and operating properly, change
the “Maximum computers” value from the default value of 64 to the
correct number of computers connected to the single Unit. This will
limit the scanning function to the actual number of computers that
are connected. Change the “Maximum computers” value as
follows:
(See page 15 for determining the “Maximum computers” value.)
a. Call up the main menu ([Ctrl], F12). (Figure 7)
b. Select “System” and press [Enter]. (Figure 8)
c. Select “Maximum computers” and press [Enter].
d. Enter the correct “Maximum computers” value and press [Enter].
e. Press [ESC] to return to the main menu.
f. Save the changes and EXIT. (Figure 15)
This completes the basic installation for a single Unit. You can switch
to any of the attached computers from the keyboard by pressing and
releasing the left control [Ctrl] key, typing in the computer port number
to switch to and press [Enter]. You can also switch to a computer by
displaying the “Computer select” menu (left control [Ctrl] key, then
press the [ESC] key). Select the computer to switch to from the list and
press [Enter]. You will be immediately switched to that computer.
(Figure 17).
To customize the configuration settings for the system, computers,
KVM stations, users, profiles, groups, and language see the
Configuration Menu section for details.
Refer to the Operation section for information on the operation of the
UltraMatrix switch.