Filter
Top Products
ULTRAMATRIX E-SERIES MANUAL
25
16. Pre-configure the CPU port, if needed, as outlined in steps 4a-f on
page 12 if the computer being connected does not use a PC2
type keyboard or PS/2 mouse (defaults). Pre-configure the CPU
port before connecting the computer. If the computer uses a PC2
type keyboard and PS/2 mouse, connect it to the corresponding
CPU port. No pre-configuration is needed.
17. Boot the computer if power is not applied. You should see the
boot up sequence on the KVM monitor. If the computer was
connected to a pre-configured CPU port with power applied, you
should see that computers video.
18. Verify that the keyboard, video, and mouse on the connected
computer function properly before proceeding.
19. Switch the KVM station to the next sequential CPU port as
explained in step 15 and perform steps 16 – 18 for the remaining
computers.
20. Connect other KVM stations as needed to the UltraMatrix switch
and verify they operate properly. (See Appendix F. for proper
KVM station placement)
Other configuration parameters can be set-up for the system,
computers, KVM stations, users, profiles, groups, and languages. See
the “Configuration menu” section for instructions on setting up these
items.
Please refer to the Operations section for using the UltraMatrix switch
and Appendix F for KVM placement and usage.
A variety of cable configurations can be designed to accomplish the
switching needs for your system. If you need assistance in designing
your system layout, contact our technical staff.