Filter
Top Products
ULTRAMATRIX E-SERIES MANUAL
23
e. Next, select “Starting computer number” and press [Enter]. An
input box will display for a new starting computer number.
Enter the correct “Starting computer” number for this Unit (See
page 15) and press [Enter].
f. Press the “Esc” key to return to the “Main menu”.
g. Select “Save” and press [Enter]. A “YES/NO” choice box will
display. Select “YES” and press [Enter] to save the change to
flash memory.
h. Turn the power off on the UltraMatrix.
i. Move the KVM station from Unit #2 to Unit #3 and connect it to
the KVM #1 connector.
j. Configure this Units “Starting computer” number and then all
other Units in the system. When the “Starting computer”
number has been entered for all Units, proceed to step 3.
3. Connect a KVM station to Unit #1’s KVM #1 connector and apply
power to the monitor and Unit #1.
4. Enter the “Maximum computers” number by:
a. Display the main menu. (Left control [Ctrl] key, then F12 key).
b. Select “System” and press [Enter].
c. Select “Maximum computers” and press [Enter]. An input box
will display for a new “Maximum computers” number. Enter the
correct “Maximum computers” value as explained on page 15
and press [Enter].
d. Press the “Esc” key to return to the main menu, select “Save”
and press [Enter]. A YES/NO choice box will display. Select
“YES” and press [Enter] to save the change.
5. Call up the system status display (left [Ctrl] key, then the F12 key).
6. Select “Status” from the main menu and press [Enter]. The system
status screen will display showing the following; (Figure 14)
1. Computers
2. Power (Power on status)
3. POS (Card position)
4. VER (Program version)
5. KVM
6. CPU
7. User
8. Status
The number of system CPU ports that Unit #1 has will be
highlighted. If the unit is a 16-port switch, computers 1-4, 5-8, 9-12,
and 13-16 will be highlighted on the status screen.
(NOTE: System CPU ports = total RS/232 ports times 4)
7. Apply power to the next unit to bus in, then connect an expansion
cable (IN THIS ORDER);
From: Unit #2’s lower “OUT” expansion card connector,
To: Unit #1’s lower “IN” expansion card connector.