Filter
Top Products
ULTRAMATRIX E-SERIES MANUAL
54
Selecting option 6 restores the CPU card to its original factory
configuration. The following message appears:
When the factory defaults have been restored, the following message
is displayed:
The serial options menu is then displayed, indicating that this CPU
board has been reset to the factory defaults.
Option 7. Save Changes
This option saves the configuration changes made in option 1 and 2
only to the CPU card where the serial cable is attached. It is
recommended that all users be logged off from all systems prior to
saving any configuration changes.
To save the configuration changes, press 7, and the following message
appears:
When the flash memory is updated, the following message is
displayed:
Option 8. Exit (Restart the Unit)
Selecting option 8 exits the serial option menu. The UltraMatrix switch
will reinitialize and the diagnostic check will run. After the diagnostic
check finished, the Unit is ready to use with its new configurations. If
there are more configurations needed, hit the space bar within 5
seconds and the serial menu will be brought back up to use.
Flash programming . . . . . . . . . . . . . . . . . . . .
Reset to default successful
Flash programming . . . . . . . . . . . . . . . . . . .
Configuration saved successfully