Filter
Top Products
ULTRAMATRIX E-SERIES MANUAL
70
Appendix G. Password jumper
If the configuration password is ever forgotten, the UltraMatrix switch
has a special “Password” reset jumper on the CPU card. This jumper
is labeled JP31 on all models. To use this jumper to bypass the
password, perform the following:
1. Turn off the UltraMatrix switch and remove the top cover.
2. Install a jumper on JP31 to short the two terminals.
The login requirement will be bypassed and you will be granted
access. This does not delete the password, only bypasses the
function.
3. Power on the UltraMatrix with the jumper in place.
4. Call up the main menu; select “System” and press [Enter].
5. Select “Configure password” from the configure system menu and
press [Enter].
6. Enter a new configuration password and press [Enter].
7. Save the new configuration password from the “Main Menu”.
8. With the new password saved, turn off the UltraMatrix switch.
9. Remove the jumper on JP31.
10. Re-install the top cover.
11. Turn the UltraMatrix on. The UltraMatrix switch will boot up and the
new password will be effective.