Samsung 560 All in One Printer User Manual


 
Replacing the ADF Rubber Pad
You can purchase a ADF rubber assembly from a Samsung dealer or the
retailer where you bought your machine.
1 Open the control panel by gripping its bottom and pulling it upward.
2. Disconnect the support on the left side of the machine from the control
panel and lift the control panel up to the complete open position
3 Remove the control panel from the machine by disconnecting the hinge
on the right.
NOTE: Be carefulno todisconnectthe connector on the controlpanel from the
machine as itturns the LCD off.
4 Using a screw driver, press the slots on the ADF rubber plate to unlatch
the plate and the ADF rubber.
5 Align the holes on the new ADF rubber and the plate and inset the tabs
on the plate into the slots on the machine. Press them until they are
latched.
6 Replace the control panel by connecting the hinge on the right first
then inserting the left arm while pushing the control panel to the right.
7 Reconnect the support and the control panel, then close the control
panel firmly until it clicks into place.
MAINTENANCE