Filter
Top Products
12 | CHAPTER 2 – CONTROLLING YOUR UX60 PROJECTOR
Part No. 99-00984-20 REV A0
12. 3.5 mm audio-input connector (for VGA 1 connector)
13. HD-DB15 (VGA 1) input connector (PC analog signal/component
video input)
14. 3.5 mm audio-input connector (reserved for wire management bundle)
15. HD-DB15 (VGA 2) input connector (reserved for wire management bundle)
16. RS-232 connector
17. RCA jack composite video input (reserved for ECP harness cable)
18. RCA jack audio-left input (reserved for ECP harness cable)
19. RCA jack audio-right input (reserved for ECP harness cable)
20. HDMI port
Remote Control
Remote Control Battery
Follow this procedure to use the remote control for the first time or to replace the
remote control battery.
To access or replace the
remote control battery
1. Turn over the remote control onto
its back.
2. Hold down the side release on the
left side of the battery holder and pull
the battery holder completely out of
the remote control.
3. Insert a CR2025 coin cell battery into
the battery holder.
IMPORTANT
Remove the plastic sheet inside
the battery holder before you
use the remote control for the
first time.