Filter
Top Products
42 | CHAPTER 5 – MAINTAINING AND TROUBLESHOOTING YOUR SMART BOARD
685ix INTERACTIVE WHITEBOARD SYSTEM
Part No. 99-00984-20 REV A0
– Wash your hands thoroughly if you have come into contact with
lamp debris.
– Thoroughly clean the area around the projector, and discard any edible
items placed in that area because they could be contaminated.
• Replacing the lamp in a wall-mounted projector can result in a fall or injury.
Use caution when climbing a ladder, or remove the projector from the
wall-mounted bracket to replace the lamp.
• Uncovering the lamp while the projector is mounted on the wall-mounting
bracket can lead to product damage or personal injury from falling pieces of
glass if the lamp is broken.
• When replacing the projector lamp:
– Turn the projector off and wait 30 minutes for the lamp to cool
completely (or before removing the projector from the wall-mounting
bracket, if necessary).
– Do not remove any screws other than those specified in the lamp
replacement instructions.
– Wear protective eyewear while changing the lamp. Failure to do so can
cause injury or loss of eyesight if the lamp shatters or bursts.
– Use only replacement lamps approved by SMART Technologies. Contact
your authorized SMART reseller
for replacement parts.
– Never replace the lamp assembly with a previously used lamp assembly.
– To prevent premature lamp failure or exposure to mercury, always handle
the fragile lamp assembly with care. Use gloves when touching the lamp.
Do not touch the lamp with your fingers.
– Recycle or dispose of the lamp as hazardous waste, in accordance with
local regulations.
To remove the old lamp 1. Turn the power off by pressing the power button twice on the remote control or
the ECP.
2. Wait at least 30 minutes for the projector to cool down.
3. Unplug the power cable from the wall outlet.