Filter
Top Products
Part No. 99-00984-20 REV A0
v | INTRODUCTION – IMPORTANT INFORMATION
• Reduce the risk associated with a leaking battery in your projector’s remote
control:
– Use only the specified coin-cell type battery
– Orient the battery’s plus (+) and minus (-) terminals according to the
markings on the remote control
– Remove the battery when the remote control is unused for an extended
period
– Do not heat, disassemble, short or recharge the battery, or expose it to
fire or high temperatures
– Avoid eye and skin contact if the battery has a leak
– Dispose of the exhausted battery and product components in accordance
with applicable regulations
CAUTIONS
• Avoid turning off the projector during the lamp ignition phase because this can
lead to premature lamp failure. Before turning off the projector, keep the lamp
on for a minimum of 15 minutes after turning it on to preserve the lamp life.
• When you switch the projector off, ensure that the cooling cycle is complete
before disconnecting the power. Allow 90 seconds for the projector to
complete the cooling cycle.
• Never operate this unit immediately after moving it from a cold location to a
warm location. When the unit is exposed to such a change in temperature,
moisture can condense on the lens and crucial internal parts. Allow the
system to reach room temperature before operation to prevent possible
damage to the unit.
• In a high altitude location where the altitude is over 6000' (1829 m), where the
air is thin, cooling efficiency is reduced, so use the projector with the fan mode
set to High.
• Do not block the projector’s ventilation slots and openings.
• Do not place in hot locations, such as near heating equipment. Doing so could
cause a malfunction and shorten the life of the projector.
• Do not set up or use the interactive whiteboard system in an area with
excessive levels of dust, dirt, humidity or smoke.
• Before you clean the UX60 projector, put the system into Idle mode by
pressing the power button twice on the ECP or remote and allow the bulb to
cool for at least 30 minutes.