Filter
Top Products
Part No. 99-00984-20 REV A0
25 | CHAPTER 4 – INTEGRATING OTHER DEVICES TO YOUR INTERACTIVE
WHITEBOARD SYSTEM
4. Remove the input/output cover by sliding it away from the projector.
5. Release the latch on the wire management clip.
To connect cables to
your UX60 projector
1. Connect your peripheral cables to the projector’s connection panel. Do not
connect any peripherals into the connectors marked in grey on the diagram on
page 11, because these are reserved for the ECP harness and wire
management bundle.
2. Place the cables across the wire management clip. Do not close the latch on the
wire management clip at this time.
3. Pass the cables between the two wall-mounting brackets behind the interactive
whiteboard.
Cabling between the two
wall-mounting brackets for
the SMART Board 685
interactive whiteboard
(not shown)