Filter
Top Products
Part No. 99-00984-20 REV A0
33 | CHAPTER 5 – MAINTAINING AND TROUBLESHOOTING YOUR SMART BOARD
685ix INTERACTIVE WHITEBOARD SYSTEM
Cleaning the UX60 Projector
WARNING
Cleaning a wall-mounted projector can result in a fall or injury. Use caution when
climbing a ladder, or remove the projector from the wall-mounting bracket to
clean it.
CAUTIONS
• Before you clean the UX60 projector, put the system into Idle mode by
pressing the power button twice on the ECP or remote control, and allow the
bulb to cool for at least 30 minutes.
• Do not spray cleaners, solvents or compressed air directly on the projector.
• Do not allow liquids or commercial solvents of any kind to flow into the
projector base or head. Do not use spray cleaners or solvents near any part of
the projector, because they can damage or stain the unit.
• Spraying the system could spread a chemical mist on some of the projector’s
components and lamp, resulting in damage and poor image quality.
• Do not scrub the surface of the mirror with the supplied cleaning cloth. Use
the cloth with a light touch.
IMPORTANT
Wipe the exterior of the projector using a lint-free cloth.
To clean the
projector’s mirror
1. Use a bellows bulb or air blower bulb (commonly found in audio-visual supply
stores) to blow off dust. Never touch the mirror with your hands or a brush.
2. If wiping the mirror is unavoidable, wear protective gloves and gather the cleaning
cloth into a ball.
3. Gently run the cleaning cloth across the mirror like you would a feather duster.
To clean the
projector’s lens
1. Use a bellows bulb or air blower bulb (commonly found in audio-visual supply
stores) to blow off dust. Never touch the lens with your hands or a brush.
2. If wiping the mirror is unavoidable, wear protective gloves and arrange the
cleaning cloth into a ball.
3. Gently run the cleaning cloth across the lens from the center to the outer area,
using the cleaning cloth like you would a feather duster.