Filter
Top Products
Command Line Interface
6-2
After connecting to the system through the console port, the login
screen displays:
Note: Command examples shown later in this chapter abbreviate the
console prompt to “SMC-AP” for simplicity.
Telnet Connection
Telnet operates over the IP transport protocol. In this
environment, your management station and any network device
you want to manage over the network must have a valid IP
address. Valid IP addresses consist of four numbers, 0 to 255,
separated by periods. Each address consists of a network portion
and host portion. For example, if the access point cannot acquire
an IP address from a DHCP server, the default IP address used
by the access point, 192.168.2.2, consists of a network portion
(192.168.2) and a host portion (2).
To access the access point through a Telnet session, you must
first set the IP address for the access point, and set the default
gateway if you are managing the access point from a different IP
subnet. For example:
Username: admin
Password:
SMC Enterprise AP#
SMC-AP#configure
SMC-AP(config)#interface ethernet
SMC-AP(if-ethernet)#ip address 10.1.0.1 255.255.255.0
10.1.0.254
SMC-AP(if-ethernet)#