Filter
Top Products
System Configuration
5-24
CLI Commands for VLAN Support – From the global
configuration mode use the native-vlanid command to set the
default VLAN ID for the Ethernet interface, then enable VLANs
using the vlan enable command. When you change the access
point’s VLAN support setting, you must reboot the access point to
implement the change. To view the current VLAN settings, use
the show system command.
SMC-AP(config)#native-vlanid 3 6-101
SMC-AP(config)#vlan enable 6-100
Reboot system now? <y/n>: y
SMC-AP#show system 6-33
System Information
===================================================
Serial Number : A324003220
System Up time : 0 days, 0 hours, 32 minutes, 51
seconds
System Name : r&d
System Location :
System Contact : Contact
System Country Code : US - UNITED STATES
MAC Address : 00-30-F1-91-91-5B
IP Address : 192.168.2.51
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.2.250
VLAN State : DISABLED
Native VLAN ID : 3
IAPP State : ENABLED
DHCP Client : ENABLED
HTTP Server : ENABLED
HTTP Server Port : 80
Slot Status : Dual band(a/g)
Software Version : v3.0.02
===================================================
SMC-AP#