Filter
Top Products
Command Line Interface
6-76
Command Usage
When SSID broadcast is disabled, the access point will not
include its SSID in beacon messages. Nor will it respond to
probe requests from clients that do not include a fixed SSID.
Example
speed
This command configures the maximum data rate at which a
station can connect to the access point.
Syntax
speed <speed>
speed - Maximum access speed allowed for wireless clients.
(Options: 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps)
Default Setting
54 Mbps
Command Mode
Interface Configuration (Wireless)
Command Usage
• The maximum transmission distance is affected by the data
rate. The lower the data rate, the longer the transmission
distance. Please refer to the table for maximum distances
on page A-4.
• When turbo mode is enabled (page 6-78) for 802.11a, the
effective maximum speed specified by this command is
double the entered value (e.g., setting the speed to 54 Mbps
limits the effective maximum speed to 108 Mbps).
SMC-AP(if-wireless g)#no ssid-broadcast
SMC-AP(if-wireless g)#