Filter
Top Products
Configuring DHCP Server
53
With this configuration, you could create the following two pools:
Pool 0: 192.168.1.2 through 192.168.1.11
Pool 1: 192.168.2.2 through 192.168.2.2
The DHCP server would automatically distribute the Pool 0
addresses only to computers connected to the interface in
the same subnet as these addresses-the LAN interface, eth-0.
Likewise, the address in Pool 1 would be distributed to the
USB-connected computer.
Adding DHCP Server Address Pools
Follow these instructions to create an IP address pool:
1. Log into Configuration Manager, click the [LAN] tab,
and then click [DHCP Server] in the task bar.
The [Dynamic Host Configuration Protocol (DHCP)
Server Configuration] page appears:
Figure 10. DHCP Server Configuration Page
Depending on your preconfigured settings, the table may
display one or more address pools, each in a row, or may
be empty.