Filter
Top Products
Miscellaneous
Error/Warning Messages
62
Warning Messages
In case of a warning, only warning messages appear. The
ALARM lamp does not light.
Warning message Possible causes and remedies
On the video monitor On the printer window display
(only for the UP-21MD)
HIT ANY KEY HIT ANY KEY This message appears when the remote control unit is used in
CAP-STOP (CAPTURE STOP) mode and when the printer
stops capturing images once images have been captured to all
memory pages (to the last point of the last memory page).
tPress any button. Printer operation is enabled after this.
INPUT MISMATCH INPUT MISMATCH • The TV system of the signal input from the source
equipment (VTR, video camera and so on) is not
compatible with the TV system of your printer.
tCheck the signal of the TV system and input the
correct one.
tCheck the setting of the NTSC/PAL selector on the rear
panel. (See page 10)
• A signal other than a video signal (such as an audio signal,
etc.) is input.
tInput the correct video signal.
NO INPUT NO INPUT • The printer is not receiving an input signal from
equipment corresponding to the input selected on the
INPUT SETUP menu.
tCheck the input signal selected on the INPUT SETUP
menu. (See page 15.)
tCheck whether the video equipment is outputting a
video signal in playback mode.
tCheck that the connections between the signal source
equipment and the printer are secure. (See page 10.)
NO IMAGE NO IMAGE The image is not captured in memory.
tCapture the image in memory then start printing. (See
page 17.)
PRINTING MEMORY PLEASE WAIT
NOW PRINTING
In the selected memory page, the captured image is being
printed or queued.
tRetry the operation once the printer finishes printing.
HEAD IN COOLING PLEASE WAIT
HEAD IN COOLING
The thermal head has overheated.
tLeave the printer until the head cools down and this
message disappears. The printer starts printing
automatically.