Filter
Top Products
Updates to the User Guide
36
Release Notes 90990009
11. Using the blade handle, slide the blade completely into the nTier700
enclosure until it is firmly seated.
12. Repeat Step 3 through Step 10 to install the drives in all of the
remaining blades.
13. After you finish installing the drives in all of the blades, slide the
chassis management module into the chassis as far as it will go. Pull out
slightly on the handle to confirm it is firmly seated.
Connect the Cables and Power On
After installing the drives in the blades, connect the cables to the system
and perform the initial power-up. Figure 7 shows the location of the
connectors used.
Note: The types of network connection between the application server
in the nTier700, the backup servers, and any physical storage
devices (a library, tape drive, or another nTier appliance),
depend on your configuration.
Figure 7 Connectors on the rear panel (N+1 power configuration shown).
Ethernet
RMM port
Ethernet
port 1port 2
Ethernet
port 4
Ethernet
port 3
Monitor
Keyboard
Mouse
USB Ports