Filter
Top Products
8-10 Sun Fire V120 and Netra 120 Server User’s Guide • December 2001
8.3.3 Viewing the LOM Device’s Event Log
8.3.3.1 Viewing the Last 10 Events in the Event Log
Type the following:
FIGURE 8-3 shows a sample event log display. The eventlog command reports the
last 10 events. Note that the first event is the oldest and that each event has a time-
stamp indicating the hours and minutes (and, if applicable, days) since:
■ the LOM device was last powered off (that is, since all power to the server,
including standby power, was last removed), or,
■ if the server has been booted since all power was last removed, then the time-
stamp indicates the number of days, hours, and minutes since the last reboot.
FIGURE 8-3 Sample LOM Device Event Log (Oldest Event Reported First)
Note – If the fans, PSU output, or supply rails fail on your server, you may need to
replace components. For information about ordering and installing field-replaceable
components, see Chapter 11.
lom> show eventlog
lom>show eventlog
Eventlog:
+0h0m0s host power on
+0h0m21s host reset
9/15/2000 17:35:28 LOM time reference
+0h3m20s Fault LED ON
+0h3m24s Fault LED OFF
+0h39m34s Alarm 1 ON
+0h39m40s Alarm 3 ON
+0h39m54s Alarm 3 OFF
+0h40m0s Alarm 1 OFF
+0h40m57s Fan 4 FATAL FAULT: failed
+0h40m58s Fault LED ON