Sun Microsystems 120 Server User Manual


 
8-16 Sun Fire V120 and Netra 120 Server User’s Guide December 2001
If you delete all the users you have set up, you will no longer see the login prompt
when you go to the lom> prompt.
8.4.7 Specifying Permissions for a Named User
By default, all four levels of permission are available to each named user you set up.
To limit users to a particular level of permission, type:
You can specify:
No parameters
This makes all four levels available to the named user.
All four parameters (for example, userperm cuar)
This also makes all four levels available to the named user.
One, two or three parameters
This makes only the parameter or parameters you specify available.
The parameters are:
c
This stands for “console permission”. It enables the named user to exit from the
lom> prompt to the Solaris prompt (as long as the Serial A/LOM port is shared
between the LOM and the console).
u
This stands for “user administration permission”. It enables the named user to
add and delete users and alter their permission levels by using the userperm
command.
a
This stands for “administration permission”. It enables the named user to change
the LOM device’s configuration variables (see Section 8.5, “Setting the LOM
Device’s Configurable Variables” on page 8-17).
r
This stands for “reset permission”. It enables the user you have named to reset
the server and to power it on and off using the LOM device.
lom> userperm username [c][u][a][r]