Sun Microsystems 220R Server User Manual


 
96 Sun Enterprise 220R Server Owner’s Guide October 1999
5. Align the disk drive to its drive bay.
Orient the drive so that the drive handle’s hinge faces the outside of the drive bay.
Note If you are replacing a drive that you removed previously, be sure to install
the drive in the same drive bay as the one you removed.
6. Holding the drive by its handle, fit the drive into the drive bay guide rails.
7. Slide the drive into the bay until it barely contacts the backplane.
8. Press carefully on the center of the drive and watch as the handle begins to close.
The drive handle begins to close as the drive engages its backplane connector.
9. Press the handle toward the drive until the latch closes, securing the drive
in place.