Filter
Top Products
Chapter 3 Administration and Network Setup 59
How to Boot the System Using a
PCI-Based Ethernet Interface
Before You Begin
Before you can boot the system over a network interface, you must complete the
installation procedure; see:
■ “How to Install the Sun Enterprise 220R Server” on page 13
Specifically, you must perform the following tasks:
■ Set up a system console; see “About Communicating With the Server” on page 28
■ Configure the PCI-based Ethernet port; see “How to Add an Ethernet Interface”
on page 49
■ Connect the Ethernet port to a network; see “How to Attach a Twisted-Pair
Ethernet (TPE) Cable” on page 52 or “How to Attach an MII Ethernet
Transceiver” on page 54
■ Power on the system; see “How to Power On the System” on page 34
Note – To boot the system over an Ethernet network, it is necessary that there be a
bootable image for Sun4u architecture somewhere on the network. For details, see
the installation instructions accompanying your Solaris software.
What to Do
1. At the ok prompt, type:
The show-devs command lists the system devices. It displays the full path name of
the hme device, similar to the example below:
ok show-devs
/pci@1f,4000/pci@5/SUNW,hme@0,1