Filter
Top Products
Chapter 5 Replacing a Disk Drive 97
10. Repeat the procedure for the other drive (if necessary).
If you have finished removing and installing disk drives, remove the antistatic strap.
11. Close and then lock the system front doors.
Turn the keyswitch to the Locked position. This locks the system front doors
preventing access to the power supply(s) and to the disk drive(s) installed in the
system.
12. If you are performing a hot-plug installation, complete the software part of the
installation procedure.
See “About Internal Disk Drives” on page 74.
What Next
When you are ready to restart the system, be sure to run power-on self-test (POST)
and OpenBoot Diagnostic (OBDiag) tests to verify that the system functions correctly
with the new parts you have just installed. You must also perform a reconfiguration
boot so that your system is able to recognize the new device(s). For additional
information, see:
■ “How to Initiate a Reconfiguration Boot” on page 98
■ “How to Use POST Diagnostics” on page 121
■ “How to Use OpenBoot Diagnostics (OBDiag)” on page 129