Filter
Top Products
3-28 Ultra Enterprise 6000/5000/4000 Systems Manual—November 1996
3
3.5.5.1 Removing a Graphics (UPA) Card
1. Use the procedures in Section 3.5.2, “Removing a Board,” to remove the
applicable Graphics I/O board.
2. Locate the card. See Figure 3-22.
3. Remove the two screws that secure the card to the Graphics I/O board
front panel.
Save the screws for installation of a replacement card or a filler panel.
4. Unlock the card by pulling up the tips of the two standoffs.
See Figure 3-14.
5. Hold the card by the edges near the connector and gently rock the card
back and forth to loosen it from the socket.
You may have to remove the SBus cards next to this card in order to have
enough room to hold onto the graphics (UPA) card being removed.
Caution – The connector housing may break if the card is tilted too far.
6. Lift the card from the socket at an angle while guiding the face plate out
from the back panel opening.
See Figure 3-22.
!