Filter
Top Products
I/O Boards and Components 3-35
3
3. Hold the card at a slight angle and position it so the fiber connector end is
loosely inserted into the I/O board front panel opening.
4. Align the card over the I/O board fiber connector receptacle and over the
four standoff holes on the I/O board.
See Figure 3-24 on page 3-33.
5. Seat the card:
a. Grasp the card underneath each corner near where the card connects to
the I/O board fiber connector receptacle. Firmly seat the card on the
connector and on the two adjacent standoffs.
b. On the end of the card near the I/O board front panel, grasp the card
underneath each side and firmly seat the remaining two standoffs.
6. Use the procedures in Section 3.5.3, “Installing a Board,” to replace the
I/O board.