Filter
Top Products
8-10 Ultra Enterprise 6000/5000/4000 Systems Manual—November 1996
8
Note – The tape drive must be installed on the side nearest the keyswitch for
cooling purposes.
6. To install a tape drive for the first time, you must first remove the filler
mechanism:
a. Remove the filler by loosening the three captive screws and then
removing the unit.
b. Separate the filler from what will become the device mounting plate by
loosening and then removing the four screws; discard the remaining
filler portion.
c. Secure the mounting bracket to the new device.
d. Set the SCSI address to 5.
e. Secure the device with the mounting bracket to the SCSI tray using the
three captive screws.
f. To complete the install, reverse Step 1 through Step 3 of this procedure.
8.2 Multi-Tape Tray and SPARCstorage Library
For use and maintenance of the Multi-tape Backup tray or the SPARCstorage
Array Library, refer to the documentation that came with the device.
8.3 External Disk Drives
There are many types of external disk drives supported by Enterprise systems,
including those contained in SPARCstorage arrays and Differential SCSI trays.
8.3.1 Use and Maintenance
For use and maintenance of individual drives, refer to the documentation that
came with the drive.
8.3.2 Removing and Installing a Disk Drive
For removal and installation of a disk drive, refer to the documentation that
came with the drive.