Filter
Top Products
Appendix A Troubleshooting 137
Hardware Error Messages
The following table shows some error messages that result from hardware issues,
possible causes of those issues, and solutions.
TABLE A-1 SunPCi III Hardware Error Messages and Solutions
Error Message Possible Cause Solution
Driver not found.
Can’t attach to
device.
Your system cannot identify the PCI device.
Your SunPCi III card might not be properly
seated in the PCI slot.
Remove and reinstall your
SunPCi III card as described in
the SunPCi III Quick Start
Installation Guide.
The SunPCi III
drivers could not be
loaded. Is another
session running?
This message might appear for one of the
following reasons:
• You already have a SunPCi III session
running.
• You removed the SunPCi III card and
then reinstalled it in a different PCI slot in
your system.
• You started SunPCi III software without
first restarting your system after you
installed the card.
Perform a corresponding action:
• Quit the other session before
running SunPCi III software
again.
• If possible, remove the card
and install it into the PCI slot it
first occupied.
• Log in as superuser, type halt
at the # prompt to halt your
system again, and restart at the
ok prompt using boot -r.
Driver couldn’t be
loaded. SunPCi III
cannot open the
device.
Your SunPCi III card might not be properly
seated in the PCI slot.
Make sure that the card is
securely seated in the PCI slot.
System could not
transfer file data
from buffers.
You have run out of disk space on your
host file system.
Make more space on your host
file system.