Filter
Top Products
Switch Management Overview
1-5
1.5.3 Supplying Power
To cable the ES3000 Ethernet Switch to receive power:
1. Connect the supplied AC power cord to the power connector on the rear of the Ethernet
Switch.
2. Plug the cord into a standard AC outlet with a voltage range from 100VAC to 240VAC.
The Ethernet Switch is ready to receive power.
1.5.4 Establishing a RS-232 Serial Connection to the Ethernet Switch
The initial configuration of the Ethernet Switch is set using the serial port. To establish the RS-232
serial connection:
1. Connect the port to a RS-232 (DB-9) serial port on the configuring computer using the
supplied cable.
2. Use a terminal emulation application to access the command line interface (CLI) through the
console port.
3. Configure the terminal emulation application and operating system to support the following
serial port specifications:
Terminal Type VT-100
Communication 8 - data bits
Mode 1 - stop bit
no parity
19200 bps transfer rate
no flow control
no hardware compression