Filter
Top Products
Administration Console Access
3-19
3.5.9 Main Menu->SNMP Config. ->Trap Selection
Three commands are available to configure individual trap parameters:
3.5.9.1 Port Link Down Trap
When on, the system generates an SNMP trap upon a port link down. This failure occurs when a link
is disconnected. Therefore, symbol recommends each port be enabled and/or disabled independently.
3.5.9.2 Link Down Trap
As authentication failure trap, all hosts in community strings with TRAP privileges are notified when
a trap condition occurs.
Enable/Disable Auth Fail Trap: Enables or disables the authentication failure trap.
Add Link Down Trap Ports: Add individual port onto the trap list.
Delete Link Down Trap Ports: Delete individual port from the trap list.
Enable The system generates a SNMP trap upon a port link down
Disable The port link down trap is not generated upon a port link down