Filter
Top Products
ES3000 User Guide
5-96
dot1x timeout re-authperiod
Use this command to set the number of seconds between re-authentication attempts. The command
affects the behavior of the switch only if periodic re-authentication is enabled.
dot1x timeout re-authperiod <minute>
S
YNTAX DESCRIPTION: <minute> Set the number of minutes
D
EFAULT VALUE:
C
OMMAND MODES: Interface configuration
R
EFERENCE:Cisco
M
ENU:
E
XAMPLE:
! Set re-authentication time 2 min on port 7
Switch(config)# interface fastethernet0/7
Switch(config-if)# dot1x timeout re-authperiod 30
Switch(config-if)#
dot1x timeout supp-timeout
Use this command to set the number of seconds for the timeout value.
dot1x timeout supp-timeout <second>
S
YNTAX DESCRIPTION: <second> Set the number of seconds
D
EFAULT VALUE:
C
OMMAND MODES: Interface configuration
R
EFERENCE:Cisco
M
ENU:
E
XAMPLE:
! Set supp-timeout 60 sec on port 7
Switch(config)# interface fastethernet0/7
Switch(config-if)# dot1x timeout supp-timeout 60
Switch(config-if)#