Filter
Top Products
WFM700 Series Waveform Monitors User Manual
1-5
Installation and Power On
This section contains information about installing and powering on the wave-
form monitor. Instructions for performing firmware upgrades are located in the
WFM700 Series Technical Reference document on the CD-ROM.
Hardware Installation
NOTE. Instructions for installing or removing the waveform monitor from a
cabinet, and for adding or removing a module from the instrument are located in
the WFM700 Series Technical Reference document on the CD-ROM.
The waveform monitor is shipped in a wrap-around chassis that covers the
instrument bottom and two sides. A cover is installed on the chassis, and the rear
panel is made up of the module rear panels.
You can operate the waveform monitor in the instrument chassis (be sure the
cover is on) or installed in an approved portable cabinet or rack adapter. You can
also install the waveform monitor in a custom installation, such as a console.
CAUTION. Do not install the waveform monitor in any cabinet except those that
are listed in Optional Accessories on page 1--4. Attempting to do so can damage
the waveform monitor and the cabinet.
If you install the waveform monitor in a custom application, such as a console,
be sure to provide adequate airflow. Follow these guidelines:
H Do not block the ventilating holes.
H Adhere to the clearance requirements that are listed in the specification tables
of the WFM700 Series Technical Reference document on the CD-ROM.
CAUTION. Failure to provide adequate airflow to the waveform monitor could
cause the instrument to shut down (refer to Table 2--2 on page 2--3 for LED fault
codes). If the airflow is blocked and the instrument does not shut down, the
instrument could be seriously damaged.