Filter
Top Products
4 Replacement Procedures 4.8 Base assembly
4-22 [CONFIDENTIAL] PORTÉGÉ R700 Maintenance Manual (960-833)
4.8 Base assembly
Removing the Base assembly
To remove the base assembly, follow the steps below and refer to Figure 4-11 to 4-13.
1. Take out the tab under the base assembly.
2. Lift up the flip of the connector and disconnect the ExpressCard FPC from the
connector CN2520 on the system board while holding the tab.
Figure 4-11 Removing the base assembly (1)
Tab
Flip
ExpressCard FPC
CN2520