Filter
Top Products
4.24 Cover assembly/LCD assembly 4 Replacement Procedures
PORTÉGÉ R700 Maintenance Manual (960-833) [CONFIDENTIAL] 4-71
Installing the Cover assembly/LCD assembly
To install the cover assembly/LCD assembly, follow the steps below and refer to Figure 4-43
and 4-44.
1. Set the PW SW button to the cover assembly while engaging the latch.
2. Connect the sensor harness to the sensor board.
3. Set the sensor board to the appli button.
4. Set the appli button to the cover assembly while engaging the latch.
5. Set the LCD assembly to the cover assembly and secure them with following screw.
• M2.5×4B FLAT HEAD ×1
6. Turn up the insulator and arrange the harnesses.
NOTE: When arranging harnesses of the left side, refer to the following figure.