Filter
Top Products
188 © 2009 VBrick Systems, Inc.
2. Click on Specify LAN Address Range(s) and enter the address range of your local LAN.
Internal users are identified by this range. Note: the VBrick encoder IP Address must be
in this range.
Portal Server User Configuration
If authentication is enabled on the Portal Server, users must be authenticated and given Live
Channel Privileges. See the Portal Server Admin Guide for more information.
Portal Server Scheduler Configuration
A live broadcast can only be initiated using the Portal Server Scheduler component. A stream
will be pushed to the configured destination, from your VBrick appliance, at the configured
date and time. You will also need to enable Ext. SAP and HTTP Push as explained below.
T To push the stream via the scheduler
1. Launch the Scheduler and go to Schedule:
Live Broadcast
2. For Video Source select VBrick.
3. Highlight your WM VBrick network appliance in the list of VBrick Host Names.
4. If the local LAN is multicast-enabled select a multicast destination, otherwise select
unicast destination.
5. Go to
Advanced Settings and enable HTTP Push.
6. If you wish to allow access to remote Portal Server clients, Enable the
EXT SAP,
otherwise leave this disabled.
7. Schedule End options should be left as
Disabled.
Figure 25. Portal Server Scheduler Page – Advanced Options