Filter
Top Products
Technical information
7-12 DocuTech 61xx Operator Guide
Xerox 4024, substance 20
(75 g/m2)
3 hole drilled
4 hole drilled
7 hole drilled
Load the paper into trays 1 and 2 with holes to
the right; load the paper into trays 3, 4, and 5 with
holes to the left.
Use the Image Shift or Reduce/Enlarge options
to avoid printing near the holes.
Fan the paper and check the paper for loose
paper plugs before loading the paper into the
trays.
Never-tear, 3 hole drilled Load the paper into trays 1 and 2 with holes to
the right; load the paper into trays 3, 4, and 5 with
holes to the left.
Do not bind or run 2-sided prints.
Never-tear Do not bind or run 2-sided prints.
3 hole drilled, edge
reinforced, 4024 DP paper
Do not stitch or bind. Do not run with tabs. Tabs
can be inserted off-line.
For optimum satisfaction, use the paper trays 1
and 2 plate assembly. The plate assembly can be
ordered by a Customer Service Representative.
Up to 500 sheets can be placed in the tray.
Load the paper into all trays with holes to the left,
reinforced side down.
Select Properties... on the Trays pull-down
menu. On the Stock window, under Type, select
Drilled.
Image quality problems may occur near the
reinforcement with side 2 printing.
Remove the paper immediately before use to
ensure that prints stay flat.
Print with no more than 200 sheets in a tray.
Select a quantity of 50 or fewer at a time.
Transparencies with a 0.5
inch (13 mm) white stripe
Load the stock with the white stripe to the right
into trays 1 and 2.
Load the shiny side up for optimum performance.
Removable stripe
transparencies
Do not load more than 50 removable-stripe
transparencies into trays 1 and 2.
With the white stripe to the right, place the
transparencies on top of approximately 50 sheets
of paper in the tray.
Do not run as inserts to a bound job. Printing is
not allowed on inserts.
Tabs Mylar tabs should be run out of tray 4.
Table 7-10. Satisfaction guide for various stocks
Stock type Instructions for use