Filter
Top Products
Routine maintenance
DocuTech 61xx Operator Guide 5-33
Refer to the procedure, Replacing the binder tape reel, in this
guide for information on how to remove and replace the
binder tape reel.
Replacing the binder tape reel
Use this procedure to replace the binder tape in the system.
To ensure proper binding and to reduce binder tape jams, do not
leave binder tape in the system when the binder is not in use.
If necessary, refer to the label on the binder for instructions on
how to replace the binder tape.
The following steps must be performed to replace the binder
tape wheel.
WARNING
All areas of the binder drawer, including the binder tape, are
hot, approximately 425°F (218°C), and may cause serious
burns. If the binder has been in a "Ready" condition, allow
the binder drawer to cool at least one hour before
continuing the procedure.
1. Open the finisher doors.
2. Grasp the green handle on the binder drawer and pull the
drawer out until it stops.
Figure 5-32. Opening the binder drawer
3. Remove the tape from the drive roll.