Filter
Top Products
Routine maintenance
5-24 DocuTech 61xx Operator Guide
Figure 5-20. Closing the fuser drawer
6. Close the processor doors.
The fuser agent message will disappear after the system makes
approximately 20 prints.
Replacing the stitcher spool A
Use this procedure to replace stitcher spool A in the system.
Check stitcher spools A and B visually during the warm-up cycle.
Stitcher spool A is the spool on top, and stitcher spool B is the
spool on the bottom.
If spool B needs new wire, call the customer support center.
Refer to the section, "Calling for assistance," in this guide.
There is a label behind the stitcher panel that gives instructions
for replacing the stitcher spool A. Refer to this label if needed.
The following steps must be performed to replace the stitcher
spool A.
1. Open the finisher doors.
2. Lift the stitcher panel, which is located directly above the
stitcher spools.
3. Pull the green stitcher head release handle forward and up
until it latches into place, as shown in figure 5-21.