Filter
Top Products
Routine maintenance
DocuTech 61xx Operator Guide 5-7
• Always use a drop cloth when replacing the dry ink cartridge,
dry ink waste container, or when adding fuser agent.
• Some parts of the system, such as the fuser, get hot during
operation. To ensure that you do not burn yourself, be careful
when working around these parts.
WARNING
The fuser can reach a temperature of approximately 425°F
(218°C). Exercise care to prevent burns when working near
this area.
• To prevent injury to yourself, always use special care when
using the wire cutters.
WARNING
All areas of the binder drawer, including the binder tape, are
approximately 425°F (218°C) and may cause a serious burn
to the operator. If the binder has been in a "Ready"
condition, allow the binder to cool for at least one hour
before attempting to clean the binder.
Cleaning the binder
Keep the binder clean to prevent binder tape jams. Clean the
binder once a week, or as needed, and also when changing the
binder tape.
It is highly recommended that the binder be cleaned before the
binder warm-up cycle begins or before switching the system on.
The following steps must be performed to clean the binder.
WARNING
All areas of the binder drawer, including the binder tape, are
hot, approximately 425°F (218°C), and may cause a serious
burn. If the binder has been in a "Ready" condition, allow
the binder to cool for at least one hour before continuing the
procedure.
1. Open the finisher doors.