Filter
Top Products
116 Zebra ZXP Series 8 Card Printer User’s Manual P1045430-002
5: ZXP Series Toolbox
Configuration
• Print Performance Setting: Performance options from the dropdown menu include:
- No error recovery (None): The printer provides high throughput with a hands-off
error recovery policy. This allows the host to have full control over how jobs are
retried, if at all.
In this mode, there can be more than one job in the system at any
time. If there is any job in the system (i.e., printer or laminator) and an error occurs,
the job will not be automatically retried by the system after the error is cleared. In
addition, jobs already in the printer that were sent after the job that had the error are
aborted. Jobs ahead of the one with the error are not affected and are allowed to
proceed to completion if possible. This mode would be used in applications requiring,
for example, uniquely-serialized cards and having no automated means of validating
the mating of a job to a card.
- Standard error recovery (Medium): The printer provides high throughput with a
reasonable-effort error recovery policy.
In this mode, there can be more than one job
in the system at
any time. If a job suffers an error it will be automatically retried after
the error is cleared. Card jams, for example, are handled this way – after the printer is
opened, the jammed card removed, and the printer closed and re-initialized, a fresh
card is fed and the job reprocesses without host intervention. Jobs ahead of the job
that had the error are not affected and are allowed to proceed to completion if
possible. Jobs behind the one with the error are paused until the error is cleared, and
then they also proceed to completion.
- Full error recovery (High): The printer provides reduced throughput so that it can
recover any job automatically. In this mode, only one job is allowed into the system at
a time; and if a job errors anywhere in the system, the job will automatically be retried
by the system after the error is cleared.
-
• Transfer Temperature Offset:
Transfer Temperature Offset is provided to globally change the temperature of the
heated rollers.
If you have a single card type and you want to change the roller temperatures, you
would use custom card type; see Card Setup Tab on page 79.
If the printer seems to be running too cold or too hot for every card type, you would
use this adjustment to raise or lower the heated roller temperature for all cards. While
you will not see a change in card parameters for a given card type when using the
Transfer Temperature Offsets, you will see the change in the OCP Info screen that
shows the temperature set-points and current temperatures.
The adjustment range is: Minimum -10, Maximum 10.