Filter
Top Products
24 Zebra ZXP Series 8 Card Printer User’s Manual P1045430-002
2: Installation and Setup
Loading the Laminate
Loading the Laminate Cassette(s)
Step 1. Remove a new roll of laminate from its packaging. There are two different laminate
rolls, one for the Upper Cassette (Blue) and one for the Lower Cassette (Yellow).
Step 2. Place the roll of laminate in the Upper Laminate Cassette (present on both the
single-sided laminator and dual-sided laminator). Note the orientation of the laminate
spool with respect to the laminate cassette as shown in the figure below.
Step 3. Pull out an inch or two of laminate past the lip of the cassette.
Step 4. Close the cassette by firmly pressing the “clamshell” together. You will hear a click
and feel a detent when the halves of the cassette seat together.
Step 5. Remove a second new roll of laminate from its packaging (for dual-sided
laminator only).
Step 6. Place the roll of laminate in the Lower Laminate Cassette (present on the dual-
sided laminator only). Note the orientation of the laminate spool with respect to the
laminate cassette as shown in the figure below.
Important • The geared flange on the laminate spool is removable, but do not remove it. If it
does come off, snap it back onto the end of the spool.