Zebra Technologies 8 Printer User Manual


 
18 Zebra ZXP Series 8 Card Printer User’s Manual P1045430-002
2: Installation and Setup
Loading the Transfer Film
Step 2. Unroll about 1 foot (30 cm) from the full roll of transfer film on the supply spool; and
wind it, 2 wraps, onto the empty take-up spool.
Step 3. Load transfer film supply spool onto the supply spindles, green flange side to
the left.
Step 4. Load the empty take-up spool onto the take-up spindles, white flange side to
the right.
Step 5. Make sure the spring-loaded spindles on the right seat into the spools.
Step 6. Make sure the transfer film comes off the bottom of the supply spool and feeds to the
bottom of the take-up spool.
Step 7. The figure below shows the proper installation of the transfer film.