Filter
Top Products
P1045430-002 Zebra ZXP Series 8 Card Printer User’s Manual 215
Appendix H
Packing the Printer with
Laminator for Shipment
Introduction
If the printer is to be shipped, it is important to use the original packing and shipping
material to prevent damage to the Printer.
If the original material is lost, a replacement Shipping Kit can be ordered from Zebra; see
the Spare Part Kits listing in the Service Manual, or check the Partner Zone at
www.zebra.com.
Procedure
Step 1. Remove any cards from the Input and Output Hoppers.
Step 2. If the unit still has power applied and is turned on and is still connected to the
host computer, set the unit’s power switch (on the back of the printer part of the unit)
to the OFF ( ) position; and disconnect the interface and power cables.
Step 3. Open the printer door, and remove the print ribbon and transfer film. If you wish to
save the print ribbon and transfer film for future use, we suggest you place them in
sealable plastic bags for storage so they do not dry out or get dirty.
Step 4. Remove the cleaning cartridge and cleaning roller, and place them in the cutouts in
the lower foam insert.
Note • The specifics of the shipment and the printer’s condition may influence which of the
following steps are followed; common sense should prevail.