Filter
Top Products
Routine Care and Adjustments
Position the Label Sensor
13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 85
To adjust the reflective sensor, complete these steps:
1. See Figure 38. Open the printhead assembly by pressing the printhead open lever.
2. Locate the reflective sensor positioning lever.
3. Move the reflective sensor positioning lever across the width of the media until the
reflective sensor aligns with the gap or notch. The glow of the red light assists in the
proper placement of the reflective sensor.
4. Close the printhead assembly.
Caution • Ensure that the printhead is fully open and engaged in the up position. If the
printhead is not latched in the up position, it could fall on your hand during the
procedure.